internet backup
aydin ovali <[email protected]>
| Newsgroups | gmane.comp.hardware.cisco.turkish |
|---|---|
| Message-ID | <[email protected]> |
merhaba;
R1=> METRO ETHERNET (Me switch ) > ISP1
R2 => LL > ISP2
þeklinde çalýþan topolojimiz var.
Isp ler ile Ebgp routerlar kendi aralarýnda ibgp konuþuyor. daha önce R1 de Me yerine LL vardý . HSRP ile active pasive þekilde çalýþýyordu. ancak Me baðlayýnca Gigabit eth Me switch ne baðlý olduðundan hat kesilse bile down olmadýðýndan active router standby a düþmüyor normal olarak . aþaðýda router larýn conflarýný yolluyorum . acaba nasýl bir conf deðiþikliðine gidebilirim .. örnek conflar varsa gönderirmiziniz. yardýmlarýnýz için þimdiden teþekkürler.
R1;
interface GigabitEthernet0/0.1 description MetroETH_TT_5mpbs encapsulation dot1Q 100 ip address 2.2.2.2 255.255.255.252!interface GigabitEthernet0/1 ip address 1.1.1.3 255.255.255.0 duplex auto speed auto standby ip 1.1.1.1 standby priority 60 standby preempt standby track GigabitEthernet0/0.1 30!interface Serial0/1/0:0 no ip address!router bgp 44444 bgp log-neighbor-changes neighbor eguven peer-group neighbor 1.1.1.2 remote-as 44444
neighbor 1.1.1.2 peer-group deneme
neighbor 1.1.1.2 update-source GigabitEthernet0/1 neighbor 2.2.2.1 remote-as 9121 ! address-family ipv4 neighbor 1.1.1.2 activate neighbor 2.2.2.1 activate neighbor 2.2.2.1 soft-reconfiguration inbound neighbor 2.2.2.1 prefix-list test no auto-summary no synchronization network 1.1.1.0 mask 255.255.255.0 exit-address-family
R2;
!interface GigabitEthernet0/1 ip address 1.1.1.2 255.255.255.0 duplex auto speed auto standby ip 1.1.1.1 standby priority 50 standby preempt standby track Serial0/1/0:0 20!interface Serial0/1/0:0 ip address 10.15.0.2 255.255.255.0 load-interval 30 no cdp enable!router bgp 44444 no synchronization bgp log-neighbor-changes network 1.1.1.0mask 255.255.255.0 neighbor eguven peer-group neighbor 1.1.1.3 remote-as 44444 neighbor 1.1.1.3 peer-group deneme neighbor 1.1.1.3 update-source GigabitEthernet0/1 neighbor 3.3.3.3 remote-as 13133 neighbor 3.3.3.3 description xnet neighbor 3.3.3.3 ebgp-multihop 3 neighbor 3.3.3.3 route-map enet out no auto-summary
_________________________________________________________________
More than messagescheck out the rest of the Windows Live.
http://www.microsoft.com/windows/windowslive/
[Non-text portions of this message have been removed]
------------------------------------
--
Cisco Teknik Tartisma Listesi (Cisco-ttl)
Bu listede onerilen degisikliklerin uygulanmasindaki tum sorumluluk
kullaniciya aittir. Liste yoneticileri, oneride bulunan liste uyeleri ya da
bu uyelerin calistigi kuruluslar herhangi bir sekilde sorumlu tutulamazlar.Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/cisco-ttl/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/cisco-ttl/join
(Yahoo! ID required)
<*> To change settings via email:
mailto:[email protected]
mailto:[email protected]
<*> To unsubscribe from this group, send an email to:
[email protected]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/