Cisco 3520 router üzerinde source NAT yapmak
serkan yetiskul <[email protected]>
| Newsgroups | gmane.comp.hardware.cisco.turkish |
|---|---|
| Message-ID | <[email protected]> |
Merhabalar
iki ethernetli bir router¹m var bir ethernetine 10.10.x.x ip grubundan adres verdim di»erine 55.236.90.x grubundan ip verdim 10.10.x.x interfaceine gelen 55.236.14.x adresine giden paketleri di»er bir routera 55.236.89.232 adresine yönlendirdim ancak giden paketlerin source adreslerini 10.10.x.x de»il 55.236.90.x adresi olmas¹n¹ istiyorum. Bu NAT tan¹mlamas¹n¹ nas¹l yapar¹m. Bu router ile bu mümkünmüdür? ip nat komutunda ilk önce pool oluºturup sonra source natm¹ yapmal¹y¹m. pool oluºtururken
ist2-3620-ES1(config)#ip nat pool stx 55.236.89.214 55.236.89.222 ?
netmask Specify the network mask
prefix-length Specify the prefix length
ist2-3620-ES1(config)#$ stx 55.236.90.214 55.236.90.222 255.255.255.240
yazd¹»¹mda netmask ta invalid input diyor. netmask yazmazsam incomplete command diyor
yard¹m lütfen
[Non-text portions of this message have been removed]
------------------------------------
--
Cisco Teknik Tartisma Listesi (Cisco-ttl)
Bu listede onerilen degisikliklerin uygulanmasindaki tum sorumluluk
kullaniciya aittir. Liste yoneticileri, oneride bulunan liste uyeleri ya da
bu uyelerin calistigi kuruluslar herhangi bir sekilde sorumlu tutulamazlar.Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/cisco-ttl/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/cisco-ttl/join
(Yahoo! ID required)
<*> To change settings via email:
mailto:[email protected]
mailto:[email protected]
<*> To unsubscribe from this group, send an email to:
[email protected]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/