RE: [cisco-ttl] Cisco 1760+ADSL Bağlantı so runu
Yucel Binici <[email protected]> Thu, 16 Jul 2009 22:54:35 -0700 (PDT)
| Newsgroups | gmane.comp.hardware.cisco.turkish |
|---|---|
| Message-ID | <[email protected]> |
Access-list goremiyorum. Orn: access-list 101 permit ip 192.168.1.0 0.0.0.255 any ip nat inside source list 101 interface dialer0 overload --- On Thu, 7/16/09, Ümit AYDINLI <[email protected]> wrote: From: Ümit AYDINLI <[email protected]> Subject: RE: [cisco-ttl] Cisco 1760+ADSL Bağlantı sorunu To: [email protected] Date: Thursday, July 16, 2009, 2:08 AM Selamlar öncelikle aşağıdaki konfigrasyonu uygulayabilirmisiniz? ! interface ATM0/0 pvc 8/35 pppoe-client dial-pool-number 1 ! dialer-list 1 protocol ip permit pvc 8/35 altına pppoe-client dial-pool-number yazmak istediğinizde hata alabilirsiniz bu komut hatırladığım kadarı ile 12.4 software ile gelmişti. Sh interface ATM0/0 ve sh inerface dialer 0 komutlarını çalıştırdığınızda çıktılarda atm0/0 ve dialer 0 spoofing durumunda mı kalıyor. -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Zeynel Büyük Sent: Thursday, July 16, 2009 8:30 AM To: [email protected] Subject: [cisco-ttl] Cisco 1760+ADSL Bağlantı sorunu Herkese merhaba, daha önce burada tartışılan 1700 serisi router ve ADSL bağlantıları nı inceledim. Aşagıdaki konfigurasyonu oluşturdum. Ancak bir türlü adsl 'e bağlanamıyorum. Acaba nerede hata yapıyorum. Yapmak istediğim router'a pppoe ile ip aldırmak ve internete çıkmak. Bu işi yaptığım yazılım ve donanımlar ise şu şekilde. Cisco 1760 router, ADSL kart,ios=c1700-sv8y7-mz.124-3 Konfigurasyonda pap olan kısmı chap olarakta denedim. Yinede bağlantı omadı. Bu konuda yardımcı olabilirmisiniz. Şimdiden herkese teşekkürler. Zeynel Büyük Router#>sh run ! version 12.3 service timestamps debug datetime msec service timestamps log datetime msec no service password-encryption ! hostname Router ! boot-start-marker boot-end-marker ! enable secret 5 $1$BXTy$ARvhpXiGyKsEEOM0wPnBL. ! mmi polling-interval 60 no mmi auto-configure no mmi pvc mmi snmp-timeout 180 no aaa new-model ip subnet-zero no ip routing ! ! ! no ip cef ip audit po max-events 100 ! ! ! ! ! ! ! ! interface ATM0/0 no ip address no ip route-cache no ip mroute-cache no atm ilmi-keepalive bundle-enable dsl operating-mode auto pvc 8/35 encapsulation aal5mux ppp dialer dialer pool-member 1 ! ! interface FastEthernet0/0 ip address 192.168.5.210 255.255.255.0 no ip route-cache speed auto half-duplex ! interface Dialer0 ip address negotiated ip access-group dialer-in in ip nat outside encapsulation ppp dialer pool 1 dialer-group 2 no cdp enable ppp authentication pap ppp pap sent-username xxxxxx@ttnet password 0 xxxxxx ! ip nat inside source list 1 interface Dialer0 overload ip classless ip route 0.0.0.0 0.0.0.0 Dialer0 no ip http server no ip http secure-server ! ! ! snmp-server community public RO ! ! line con 0 line aux 0 line vty 0 4 password xxxxx login ! end [Non-text portions of this message have been removed] ------------------------------------ -- Cisco Teknik Tartisma Listesi (Cisco-ttl) Disclaimer: Some of the individuals posting to this site, including the moderators, work for Cisco Systems, Inc. Opinions expressed here and in any corresponding comments are the personal opinions of the original authors, not those of Cisco. Yahoo! Groups Links ------------------------------------ -- Cisco Teknik Tartisma Listesi (Cisco-ttl) Disclaimer: Some of the individuals posting to this site, including the moderators, work for Cisco Systems, Inc. Opinions expressed here and in any corresponding comments are the personal opinions of the original authors, not those of Cisco. Yahoo! Groups Links [Non-text portions of this message have been removed] ------------------------------------ -- Cisco Teknik Tartisma Listesi (Cisco-ttl) Disclaimer: Some of the individuals posting to this site, including the moderators, work for Cisco Systems, Inc. Opinions expressed here and in any corresponding comments are the personal opinions of the original authors, not those of Cisco. Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/cisco-ttl/ <*> Your email settings: Individual Email | Traditional <*> To change settings online go to: http://groups.yahoo.com/group/cisco-ttl/join (Yahoo! ID required) <*> To change settings via email: mailto:[email protected] mailto:[email protected] <*> To unsubscribe from this group, send an email to: [email protected] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/