Re: pci.asm

Ken,

The code was provided by one of our members.  I've never had the need to
change anything it does so I've always just linked in the object code.
Maybe someone on the Opensource list can help you.

I would like to have a fully compilable source code so I am interested in
your question.  I may be mistaken but as I recall talking to the PCI bus
controller uses 32 bit IO port commands that might not be supported in some
early compilers/assemblers.  Does anyone else have any ideas?

I hope this helps,

Cliff
----- Original Message ----- 
From: "Ken Teo" <[email protected]>
To: "Clifford Kelley" <[email protected]>
Sent: Tuesday, February 07, 2006 1:16 AM


> Hi Mr Kelley,
>
> I try to recompile the pci.asm using BC 3.1 to obj file and include it as
an
> obj file in the project file, when I performed a built all, the linker
said
> that pci_is_bios_present symbol and some other pci functions cannot be
> found. I used tasm.exe to compile it to obj file, or are there other
methods
> to do it. Please enlighten, thanks.
>
>
>
> Best Regards
> Ken Teo
> DSO National Labs
> DID: 68713061