Re: Thanks for your help!!
Clifford Kelley <[email protected]> Wed, 25 Oct 2006 19:04:04 -0700 (GMT-07:00)
| Newsgroups | gmane.comp.hardware.gps.opensource |
|---|---|
| Message-ID | <33236542.1161828244761.JavaMail.root@elwamui-rubis.atl.sa.earthlink.net> |
Dear Yung, I'm sure the readin_com function has not been tested. It would take me some time to look over the code. Perhaps someone on the mailing list would be interested in checking this out for getting differential correction data etc. Best regards, Cliff -----Original Message----- From: N28941117_FU Sent: Oct 24, 2006 2:06 AM To: [email protected] Subject: Thanks for your help!! Dear Sir, Therer are two GPS1005 GPS Receivers in my Lab. The cersion of the propram which I used is 1.16. There is a readln_com function in serport.cpp file. I will sent some data to the PC(GPS 1005 installed inside in the PC) through RS232, so I will modify the source code. But I failed.@@ And I got one IBMCOM_C serial port library from internet(attached zip file). But I fail again.@@ Would you give me a example to modify the source code to read the data from RS232? thanks a lot. Yung Fu Tsai =========================================== Yung Fu Tsai Mechatronics Lab., EE, NCKU TEL? +886 6 276-3880 FAX?+886 6 276-3880 [email protected] =========================================== mailto:[email protected] _______________________________________________ opensource_gps mailing list [email protected] http://lists.psas.pdx.edu/cgi-bin/mailman/listinfo/opensource_gps