Re: Dual Hex small piston compressor (repost)

"Paul Krieg" <[email protected]>
Newsgroups gmane.comp.hardware.lego.robotics
Organization None
Message-ID <[email protected]> 
Hi Kevin,
  Your compressor is very nice.  I am fascinated by your crank.  I hope I am
seeing it right.  It seems a very clever way of getting the amount of travel
right and allowing the use of those pulleys with cross holes to connect all the
piston rods to the crank.  The 2 halfs of your compressor look as though they
can run independently of one another.  Is this true, or are they some how
mechanicaly connected?  Thank you for sharing it.

Regards, Paul
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.