Re: IRW strange behavior after making conf with irrecord? Alternating results.

On 19/03/17 15:43, Mark Hutchinson wrote:
> Hello,
>
> I have made a conf file for a remote control with irrecord ( see below )
>
> Using that conf file, I get odd behavior testing it with irw.
>
> on pressing number one for instance, it will give KEY_1 the first time
> then KEY_2 the second time, then KEY_1 the third time.
>
> It alternates.  Same every time I try it.  I have tried to make a new
> irrecord conf file, but got the same results.
>
> Any ideas on what I can try?

Basically, since irrecord has produced a file with raw codes, it has not 
been able to decode the remote signals completely. So, this is most 
likely about the config file.

You might want to re-check the trivial problems (ambient light, bad 
remote batteries, distance remote <-> receiver...) and re-run irrecord. 
If you still cannot create a non-raw config file, your next stop might 
be irscrutinizer; perhaps Bengt can provide some info here?

Note that the lirc version you are using is very old and not supported 
upstream i. e., I don't really know what I'm talking about here ;)


Cheers!

--alec

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot