Re: Proper blaster config in this file?
Alec Leamas <[email protected]>
| Newsgroups | gmane.comp.hardware.lirc |
|---|---|
| Message-ID | <[email protected]> |
On 22/03/17 19:42, John Adams wrote: > On Wed, 22 Mar 2017 19:02:45 +0100 > Bengt Martensson <[email protected]> wrote: > >> On 03/22/17 17:45, John Adams wrote: >>> On Wed, 22 Mar 2017 15:42:31 +0100 >>> Bengt Martensson <[email protected]> wrote: >>> >>>> >>>> Yes, I can tell you. The signals are RCMM or Nokia32. This does not >>>> decode one bit at a time on one of two bursts (ZERO and ONE), but >>>> decodes TWO bits at one of four bursts (ZERO, ONE, TWO, THREE). >>>> IIRC, Lirc can handle this on reading, but it was never >>>> implemented for sending. >>>> >>>> Other than this, the files are fine, and import without problems in >>>> IrScrutinizer. >>>> >>>> Greetz, >>>> >>>> Bengt >>> >>> I have been using RCMM sending with lirc for the last couple of >>> years. It works perfectly for me (after I blocked the nearby mirror >>> reflection). >> >> Hmm, man lircd.conf(5) sez: >> >> >> RCMM >> The remote uses the RC-MM protocol (transmitting not >> supported). >> >> so at least one is not "telling the truth". We should clarify. >> >> Greetz, >> >> Bengt >> https://sourceforge.net/p/lirc/tickets/276/ --alec ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot