Re: LIRC using with directly wiring the endpoints.

On 10/16/17 22:23, Rajendra Panchal via LIRC-list wrote:
> Hello All:
> 
> I am new to the LIRC list.
> 
> After going through the LIRC community for solution and trying all the 
> suggestions, I tried to go through source code.
> 
> I am trying to replace the IR sensor and IR transmitter between RPI3 and 
> an HDMI switch (lirc.conf generated using irrecord is attached).
> First I tested the codes over IR. works fine.

It took me quite some time to understand what you want to achieve... You 
want to take the "electric" IR signal from Lirc and feed it into the 
HDMI switch with a wire, thus bypassing the IR transmission.

Here: https://github.com/z3t0/Arduino-IRremote/issues/494 that issue was 
raised in the context of the Arduino IRremote. There is some good advice 
there, in particular inversion and opto couplers.

You should turn off modulation in lirc by the line

FREQUENCY  0

in lircd.conf. Do nut fumble with TOGGLE_BIT.


Let us know if this helps.

Greetz,

Bengt

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot