Re: LIRC using with directly wiring the endpoints.

Thanks Bengt:

Setting the frequency to 0 in lircd.conf did not make any difference when I ran irsend on source RPI3 and monitoring the receiving Rpi3 gpio22 using mode2 -d /dev/lirc0.
I have  lirc (0.9.0~pre1-1.2) installed on both RPI3.
I'm not sure if I have the latest version that supports frequency feature.

Raj

> On Oct 22, 2017, at 7:57 AM, Bengt Martensson <[email protected]> wrote:
> 
>> On 10/22/17 14:36, Raj Panchal wrote:
>> Thank you Bengt:
>> To test out IR HW bypass, first I'm using two RPI3, connecting the GPIO22 and ground pins on RPI3-TX TO GPIO23 and ground RPI3-RX. I added "frequency 0" to the lircd.conf which was originally generated using the irrecord utility..  I'm not using the optocoupler. Does the "invert=on" invert the waveform completely or should I manuallymodify in the lircd.conf? Since there is no remote control there is no need to invert to save battery power.
> 
> I do not know what "invert=on" is.
> 
> You need to invert if you are emulating a standard demodulating receiver, TSOP-**** for example, as I think I wrote in the quoted Arduino-IRremote issue. It has nothing to do with saving power.
> 
> "Top posts" are frowned upon in this community.
> 
> Greetz,
> 
> Bengt
> 
> ------------------------------------------------------------------------------
> Check out the vibrant tech community on one of the world's most
> engaging tech sites, Slashdot.org! http://sdm.link/slashdot


------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot