Re: LIRC using with directly wiring the RPI3-1 (GPIO18) and (GPIO17) on RPI3-2.

 Hi All:
 
>I would stop lircd on the receiving side, and use mode2 instead; command >line
>    mode2 --driver=default
Screenshot  https://www.dropbox.com/s/mlmii82rpx9kcgl/5.Screenshot%20after%20rebooting%20RPI3-2%20and%20using%20mode2.png?dl=0
shows nothing is received when running mode2 after reboot and killing lircd

>If that does not give any output, you likely have a hardware problem.
I don't think HW is a problem. Here are the screen shot of before & after:
1.Screenshot using IR HW after a fresh reboot  : https://www.dropbox.com/s/t7ocme1ygspyrgc/1.Screenshot%20using%20IR%20HW.png?dl=0
2.Screenshot after IR HW bypassed:
(Simply removed GPIO18 of  RPI3-1 from the  IR TX,removed GPIO17 of RPI3-2  from the IR sensor andthen directly connecting the GPIO18-RPI3-1----->GPIO17-RPI3-2.Other wires untouched)  
https://www.dropbox.com/s/t7ocme1ygspyrgc/1.Screenshot%20using%20IR%20HW.png?dl=0

3.Screenshot of same as 2 above after reboot
https://www.dropbox.com/s/kfthz6tck963k8f/3.Screenshot%20after%20reboot.png?dl=0

4.Screenshot making sure modules are same on both the RPIs.
https://www.dropbox.com/s/0cb7fh1k4h6e2b4/4.Screenshot%20making%20sure%20modules%20are%20same.png?dl=0

Then repeated the test 1 above. Works with IR HW.

Greatly appreciate any help from the lirc community on this IR HW bypassing journey (controller and the controlled devices are within the same enclosure)
Regards,Raj

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot