How to catch raw codes ?

Hello.

I want to perform manual decoding of air cooler device. The remote control
can send a huge variety of commands; and I am not going to record every
single of them in my lirc conf.

I would like LIRC to call my app (bash shell script, possible via irexec),
and pass me as argument the binary value received after timings decoding.
I want to leave LIRC convert the timings sequence into a serie of 0s and
1s. And then, I handle the myself.

This is performed here using pigpio, without LIRC:
http://blog.bschwind.com/2016/05/29/sending-infrared-commands-from-a-raspberry-pi-without-lirc/

but I would like to try using LIRC. I have a working /dev/lirc0 (which
produces mess when I press my remote).

Thanks.

-- 
 >o_/ DEMAINE Benoît-Pierre (aka DoubleHP) http://benoit.demaine.info/
If computing were an exact science, IT engineers would'nt have work \_o<

"So all that's left, Is the proof that love's not only blind but deaf."
(FAKE TALES OF SAN FRANCISCO, Arctic Monkeys)


------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot