Re: first cry for help in 5 years - config file for CiscoISB7500

On 3/3/19 6:27 PM, Matthew Ward wrote:
> Short version:  it works!  and i'm happy!  Thanks!

Congrats!

> Long version:  what i had from long ago MAY have been OK - but the real
> culprit in my case was apparently hardware related.
> 
> works for all BUT the U-Verse remote:  the TIRA-2.1
> works for ALL:  that old IRToy i had lying around that i re-flashed the
> firmware on.
> 
> does anyone know if the TIRA has any known issues with this particular
> type of IR signals (the "Nokia32" / RCMM) protocols?

All receivers have an "issue" with that protocol, since it requires to 
distinguish between some durations that do not differ very much.
So my general recommendation is

1. Use clean signals in the configuration file, for example generated by 
IrScrutinizer, NOT anything that irrecord has spat out.

2. Reduce the parameters eps (default 30) and aeps (default 100). FWIT, 
the parameters I use in IrpTransmogrifier are 4 and 50 respectively.

Or possibly try to avoid that protocol alltogether...

Greetz,

Bengt