Re: mode2 shows output, irrecord fails (using the remote out port of an amplifier)

Dear Matthias,

Am 05.03.20 um 23:00 schrieb Matthias Reichl:
>> Is there any way to invert the signal on the software side? The gpio-ir
>> kernel module in 4.19.66-v7+ apparently does not have a parameter for
>> that
> I've pushed a PR to make the signal polarity configurable in the
> gpio-ir device tree overlay:
> 
> https://github.com/raspberrypi/linux/pull/3490
> 
> I also posted an answer in the thread on the RPi forum and attached
> the enhanced gpio-ir.dtbo file there (just copy it to /boot/overlays)
> 
> https://www.raspberrypi.org/forums/viewtopic.php?p=1622026#p1622026

Thank's a lot! It works like a charm. Problem solved. :-)


Best regards,
Robert