Re: RFC: Make ethernet phy mode RMII the default

Hi Uwe,

in most designs, we normaly use RMII mode anyway, because it needs less
connections.

AFAIK MII mode is only needed for some AT91 platforms. So I would
suggest to make RMII mode the default for most platforms and keep MII as
default only for those AT91 drivers. What do you think?

Best regads,

Ole

Am 04.07.2015 13:35, schrieb Uwe Bonnes:
> Hello,
> 
> at present, our configuration makes MII mode the default and only RMII mode
> can provide a configuration marker via provides{}. That way when RMII mode is
> needed, I see no way to skip MII pin configuration in the pin configurator.
> 
> So I request to make RMII mode the default. That way, MII mode may provide a
> marker and phy pin configuration can require{} this marker.
> 
> !!! This is a user visible change!!!
> 
> Thanks
> 

-- 
kernel concepts GmbH            Tel: +49-271-771091-14
Sieghuetter Hauptweg 48         Mob: +49-177-7420433
D-57072 Siegen
http://www.embedded-it.de
http://www.kernelconcepts.de
_______________________________________________
http://lists.egnite.de/mailman/listinfo/en-nut-discussion