Re: EIR and running code in XRAM

Dear Harald,

I succeeded in running code from SDRAM using OpenOCD as suggested. Initially
the code runs fine, but after a few seconds the board just hangs. It doesn't
matter if I keep the Telnet session alive or if I shut it down. The same
behavior also happens with other example programs I've tried. I'm wondering
what's happening here.

Besides this, I think there's a small mistake in the final board
configuration file for the Elektor Internet Radio in Part 8 of the OpenOCD
for AT91SAM7SE tutorial. In proc eir_init{}  the line eir_init_membus is
missing.  Also in eir_init_clock the line mww 0xfffffc20 0x00000701 is
changed into 0x00000601. However, I don't think this is the cause of the
behavoir described above.

Best regards,

Charlie



-----Original Message-----
From: en-nut-discussion-bounces-inJ12LbcDfezQB+pC5nmwQ@public.gmane.org
[mailto:en-nut-discussion-bounces-inJ12LbcDfezQB+pC5nmwQ@public.gmane.org] On Behalf Of Harald Kipp
Sent: Friday, September 18, 2015 12:51
To: [email protected]
Subject: Re: [En-Nut-Discussion] EIR and running code in XRAM

Hi Charlie,

On 16.09.2015 18:18, C. Bonnemayer wrote:

> As a test program I use the uart example which is provided whith 
> ethernut. I use SAM-BA 2.15 to upload the code to the board. When I 
> save the code to sdram (after enabling the sdram) it does save and 
> compare the code correctly, but a go 0x20000000 (that's 7 times 0) just
does nothing.

Not sure about the compare. SDRAMs are tricky and may contain the right
code...until after a few milliseconds later...

When code is uploaded directly to SDRAM, one has to make sure, that the
programmer correctly initialized the SDRAM. Unfortunately I didn't try
SAM-BA for a long time, but typically use OpenOCD with the EIR.

http://www.ethernut.de/en/hardware/eir/openocd_sdram.html


> When I try a for sdram precompiled example from Atmels at91sam7se-ek 
> software package it just runs fine. Therefore  I think there's 
> something wrong with the at91sam7se512_xram.ld linker script or the 
> crtat91sam7se512_xram.s startup file, but I have just too little 
> knowledge about this.

Just a few weeks ago I updated an older application on the EIR (debugging in
SDRAM, final in Flash) without any problems. I used a rather new toolchain,
but a modified Nut/OS 5.1. If you still can't solve it with the information
above, I can grab out the board and try again with the official version.

Regards,

Harald

_______________________________________________
http://lists.egnite.de/mailman/listinfo/en-nut-discussion

_______________________________________________
http://lists.egnite.de/mailman/listinfo/en-nut-discussion