Re: STM32 Rework
Uwe Bonnes <bon-1JbLm1bU5j5ZIx36JBfelj3+ndqKAYMe9FMPySWZwLkb1SvskN2V4Q@public.gmane.org>
| Newsgroups | gmane.comp.hardware.microcontrollers.ethernut |
|---|---|
| Message-ID | <[email protected]> |
>>>>> "Ole" == Ole Reinhardt <ole.reinhardt-L1vi/[email protected]> writes: Ole> Hi Uwe, do we just have support for the STM32F411? This would be Ole> really great :) Ole> If not, do you know what need to be changed to support this Ole> controller types? Yes, STM32F411 is supported. I used it in several projects with the F411 nucleo boards: - Read out one wire sensors and store in values in internal flash for later retrieval. Battery powered, mean current below 2 mA. - Read out 8 NTC sensors and send values on the USB serial line - Read out 8 PT1000 at LN2 temperature. Only power the PT1000 while measuring to keep thermal load in Dewar low. - Write some pattern to internal flash via serial line and play back pattern read out with some external signal for some laser pattering. I can provide projects if needed. Most work done in the projects is done by connecting DMA event together to keep actual CPU work low. B.t.w. consider the L476: - Adds CAN, QSPI, Batterie-powered Backup SRAM, 3 * Uart at comparable prices, actual lowe at farnell. The F411 is similat to the F401 witha F401 Nucleo configuration provided. Bye -- Uwe Bonnes bon-1JbLm1bU5j5ZIx36JBfelj3+ndqKAYMe9FMPySWZwLkb1SvskN2V4Q@public.gmane.org Institut fuer Kernphysik Schlossgartenstrasse 9 64289 Darmstadt --------- Tel. 06151 162516 -------- Fax. 06151 164321 ---------- _______________________________________________ http://lists.egnite.de/mailman/listinfo/en-nut-discussion