Re: STM32F103 USART
Uwe Bonnes <bon-1JbLm1bU5j5ZIx36JBfelj3+ndqKAYMe9FMPySWZwLkb1SvskN2V4Q@public.gmane.org>
| Newsgroups | gmane.comp.hardware.microcontrollers.ethernut |
|---|---|
| Message-ID | <[email protected]> |
>>>>> "Achim" == Achim <[email protected]> writes: Achim> I just need USART1. I´m not sure if to use the stm32_usart Achim> functions directly or calling the functions via the Achim> usart-functions in nut/dev/usart.c (in the case that all the Achim> stm32 functions are registered over dcb... Did you try app/uart? Your board/xxx.h file shoudl define the device to use. Then app/uart should compile fine and work. Bye -- Uwe Bonnes bon-1JbLm1bU5j5ZIx36JBfelj3+ndqKAYMe9FMPySWZwLkb1SvskN2V4Q@public.gmane.org Institut fuer Kernphysik Schlossgartenstrasse 9 64289 Darmstadt --------- Tel. 06151 162516 -------- Fax. 06151 164321 ---------- _______________________________________________ http://lists.egnite.de/mailman/listinfo/en-nut-discussion