Re: STM32: Problems running code with an offset in flash (bootloader)

Hi Coleman,

for AT91SAM7X I have a working solution based on an older Nut/OS Version
(4.10 if I remember correctly). If you like I can send you some sources.
I never faced any similar problems there.

The ISR vector code works different than CM3/CM4.

Best regards,

Ole



Am 03.03.2016 um 17:46 schrieb Coleman Brumley:
>> cmsis/cortex_init.c line 431 is in charge to remap the interrupt vectors.
> 
> Is this also a potential issue with the AT91SAM7X? I’m working on a similar project, and I’m just wondering if this is something I need to look out for.
> 
> Regards,
> Coleman
> 
> 
> _______________________________________________
> http://lists.egnite.de/mailman/listinfo/en-nut-discussion
> 

-- 
kernel concepts GmbH            Tel: +49-271-771091-14
Sieghuetter Hauptweg 48         Mob: +49-177-7420433
D-57072 Siegen
http://www.embedded-it.de
http://www.kernelconcepts.de
_______________________________________________
http://lists.egnite.de/mailman/listinfo/en-nut-discussion