Re: Trunk 6420, how to set USART3 pin mapping on STM3240G?

Michael Fischer <[email protected]> Mon, 11 Apr 2016 20:17:23 +0200

Newsgroups	gmane.comp.hardware.microcontrollers.ethernut
Message-ID	<[email protected]>

Hello Uwe,

it looks better, uart.h contains now the correct pin mapping.

 >Is USART3 PC10/PC11 the default UART connection for debug?
 >Then perhaps stm3240g-eval.conf needs to be adapted. However
 >PC10/11 eventually collides with D2/D3 of the MicroSD connector.
I would say yes. It is the default, connected to the SUB-D9 and at the
same time it is D2/D3 from the MicroSD connector.

I will check it tomorrow with a real hardware.

Best regards,
Michael

_______________________________________________
http://lists.egnite.de/mailman/listinfo/en-nut-discussion