Break Error

Uwe Bonnes <bon-1JbLm1bU5j5ZIx36JBfelj3+ndqKAYMe9FMPySWZwLkb1SvskN2V4Q@public.gmane.org> Tue, 17 May 2016 17:53:56 +0200

Newsgroups	gmane.comp.hardware.microcontrollers.ethernut
Message-ID	<[email protected]>

Hello Ole,

can you explain what a "BREAK ERROR" in serial handling is? I looked at the STM32
reference manual, and someting like "BREAKERROR" is not mentioned there. Probably
a line kept low for longer than one frame should produce a BREAKERROR? Where does
it differ from a framing error?

Bye
-- 
Uwe Bonnes                bon-1JbLm1bU5j5ZIx36JBfelj3+ndqKAYMe9FMPySWZwLkb1SvskN2V4Q@public.gmane.org

Institut fuer Kernphysik  Schlossgartenstrasse 9  64289 Darmstadt
--------- Tel. 06151 1623569 ------- Fax. 06151 1623305 ---------
_______________________________________________
http://lists.egnite.de/mailman/listinfo/en-nut-discussion