Re: Break Error
Uwe Bonnes <bon-1JbLm1bU5j5ZIx36JBfelj3+ndqKAYMe9FMPySWZwLkb1SvskN2V4Q@public.gmane.org> Wed, 18 May 2016 11:15:48 +0200
| Newsgroups | gmane.comp.hardware.microcontrollers.ethernut |
|---|---|
| Message-ID | <[email protected]> |
>>>>> "Michael" == Michael Jones <Michael.e.Jones-S0/[email protected]> writes: Michael> Hello Uwe, The break condition is issued when the signal is Michael> held low longer than die total frame length. The Frame error on Michael> the other side indicates that e.g. the parity bit is Michael> invalid. The break state is often used in old protocols to act Michael> as a 257th character mostly as begin-of-frame or out of band Michael> data indicator. If I understand right, you explain a break condition. But what is a "break error"? Bye -- Uwe Bonnes bon-1JbLm1bU5j5ZIx36JBfelj3+ndqKAYMe9FMPySWZwLkb1SvskN2V4Q@public.gmane.org Institut fuer Kernphysik Schlossgartenstrasse 9 64289 Darmstadt --------- Tel. 06151 1623569 ------- Fax. 06151 1623305 --------- _______________________________________________ http://lists.egnite.de/mailman/listinfo/en-nut-discussion