Reworked qnutconf and nutconfigure

Hello,

for me, qnutconf crashed in a lot of circumstances and nutconfigure
required a lot of command line options to work sensible like qnutconf needed
a lot of settings changed manually.

With the recent set of changes, running "qnutconf <xxx.conf> with xxx.conf
in the Nut/OS distribution and pressing Build-> Build Nut/OS -> Yes should
run successfully. In the same sense "nutconfigure -c <xxx.conf>
create-buildtree" is enough.

As both programms are some of the first things new users get in touch with
Nut/OS, please review the changes and comment. For qnutconf, please also try
with "~/.configure/egnite/QNutConf.conf" removed, as that is the case for
new users.

Cheers

-- 
Uwe Bonnes                bon-1JbLm1bU5j5ZIx36JBfelj3+ndqKAYMe9FMPySWZwLkb1SvskN2V4Q@public.gmane.org

Institut fuer Kernphysik  Schlossgartenstrasse 9  64289 Darmstadt
--------- Tel. 06151 1623569 ------- Fax. 06151 1623305 ---------
_______________________________________________
http://lists.egnite.de/mailman/listinfo/en-nut-discussion