Re: Is STM32F412 supported?
Krzysztof Sawicki <[email protected]> Tue, 8 Nov 2016 16:12:23 +0100
| Newsgroups | gmane.comp.hardware.microcontrollers.ethernut |
|---|---|
| Organization | Mlabs sp. z o.o. |
| Message-ID | <[email protected]> |
On 26.10.2016 09:15, Krzysztof Sawicki wrote: > On 25.10.2016 11:09, Uwe Bonnes wrote: >>>>>>> "Krzysztof" == Krzysztof Sawicki <[email protected]> writes: >> >> Krzysztof> Hi, I've got Nucleo-F412ZG board. Is it supported by NutOS? I >> Krzysztof> see another nucleo boards in configurator but the one is >> Krzysztof> quite new. >> >> For STM32, using SVN Head is a must. I got my Nucleo-F412ZG last Friday and >> entered the .conf on Monday. >> >> The Display is nice. I think how to make usefull with NutOS... > > Great, just updated few hours before you comitted, that's why I didn't see this. > But... You comitted discovery board and I've got nucleo board - there are not the same! > Now I'm going to prepare conf for nucleo and post it on list... Ok, got simple config file for NUCLEO-F412ZG board. -- Krzysztof Sawicki MLabs sp. z o.o. ul. Kaliska 21 61-131 Poznań tel. 61 646 84 27 KRS: 0000390306 NIP: 7822533401 -------------- next part -------------- PLATFORM = "NUCLEO144" CM3_GCC = "" LDSCRIPT = "stm32_flash" MCU_STM32F412ZG = "" HSE_VALUE = "8000000" HSE_BYPASS = "ENABLE" LSE_VALUE = "32768" -- UART3 on PD9/PD8 DEBUG_USE_UART = "DEV_UART3" USART3_RX = "PD09" USART3_TX = "PD08" _______________________________________________ http://lists.egnite.de/mailman/listinfo/en-nut-discussion