CM3 code: Enabling debug info

Hello everyone,

I remember to have an option in the settings dialog of qnutconf where I
could switch the compiler, e.g. cm3-gcc or cm3-gccdbg. This was
practical, as the latter had the flags configured to disable
optimization and enable debug info in the binary. A while ago, this
setting disappeared and now we have the compiler choice in the tree, but
without the option to produce debug code. How can I get this feature
back in a clean way? I'd rather not mess around with the Makefiles, an
option that can be set right before compiling the libraries would be
much easier.

Thanks and best regards,
Philipp
_______________________________________________
http://lists.egnite.de/mailman/listinfo/en-nut-discussion