Re: picp 0.6.7 released
Wayne Topa <[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.gnupic |
|---|---|
| Organization | Organized? Who me? |
| Message-ID | <[email protected]> |
Jeff([email protected]) is reported to have said: > > Picp supports serial and USB interfaces to programmers using the PicStart > Plus protocol. Parallel port programmers are a different animal altogether. I > believe there are Linux programs to interface to at least some of the > parallel port programmers that are available, but those programmers are > beyond the scope of picp. > Jeff www.sparkfun.com sells a "MPLAB Compatible 8/14/18/28/40 Pin ZIFF+ICSP programmer. They say it is "fully recognized under MPLAB as a PicStart+ device". From the above it seems to fit your Picp to a tee. Am I correct? I write this as I'm downloading picp and friends. Thanks! Wayne -- Math problems? Call 1-800-[(10x)(ln(13e))]-[sin(xy)/2.362x] _______________________________________________________