Re: sdcc/PIC howto, first draft is up

On Sun, 2005-07-24 at 09:59 -0400, Byron A Jeff wrote:

> > 
> > OH , and hey kids, don't forget to disable low voltage programming if
> > you don't use it and don't have anything connected to the LVP PGM pin !
> 
> That's a requirement Peter. The LVP pin should be pulled down with a
> 10K resistor if you're doing high voltage programming.

I first learned about this 2 years ago when I first stared to play with
PICs, but since then I've always used the same fuse settings on 16F
devices, so it was a lesson I had to relearn when working out the config
settings for 18F devices....  ;-)

Peter