Re: Breadboard question (gpsim)

> Hey Guys,
> I was trying to simulate a little program that required input changes on
> the input pins. I used to do this buy just double clicking the green
> arrows on the breadboard and they would turn red. But this doesn't work
> any more. I can double click the output pins and they change but not the
> input pins. Has this been changed since the "stimulus file" function was
> added?
> BTW I'm using gpsim 0.21.9

Try it now (where 'now' =  three hours past the time stamp of this
message). You should be able to double click on a pin to change its state.
This will not work (yet) for pins configured as outputs or for pins being
driven by other sources.

I also fixed the attribute warning messages that get displayed whenever
you click on the processor in the breadboard window. And, you can now edit
the attributes from within the breadboard window too.

Scott