Re: Breadboard question (gpsim)

Thanks Scott!!
It's a big help,
Wayne
On Sun, 2005-09-11 at 10:01 -0700, Scott Dattalo wrote:
> > Hey Guys,
> > I was trying to simulate a little program that required input changes on
> > the input pins. I used to do this buy just double clicking the green
> > arrows on the breadboard and they would turn red. But this doesn't work
> > any more. I can double click the output pins and they change but not the
> > input pins. Has this been changed since the "stimulus file" function was
> > added?
> > BTW I'm using gpsim 0.21.9
> 
> Try it now (where 'now' =  three hours past the time stamp of this
> message). You should be able to double click on a pin to change its state.
> This will not work (yet) for pins configured as outputs or for pins being
> driven by other sources.
> 
> I also fixed the attribute warning messages that get displayed whenever
> you click on the processor in the breadboard window. And, you can now edit
> the attributes from within the breadboard window too.
> 
> Scott
> 
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: [email protected]
> For additional commands, e-mail: [email protected]
>