Re: [PIC] piklab now supports ICD2 and PICkit 2 programmer under Linux

On 2/17/06, Scott Dattalo <[email protected]> wrote:
>
> > Hopefully piklab/ICD2 will work with quite some dsPICs. Some
> > of the dsPICs should be supported but I have not tested any
> > dsPICs yet with piklab. I will do it soon with a 30F2010
> > using ICD2.
>
> At one time, gpsim supported the ICD (but this code has not been
> maintained). Now that I have an ICD2, I'll probably look into what it
> takes to add support for it.
>

Nicolas is working on ICD2 debugging under Linux with piklab for the
16F device. Currently it is partially working.

By the way, the tests on PICkit 2 shows that piklab supports most of
the baseline and mid-range PICs supported by Microchip PICkit 2
firmware version 1.10. It only has some minor bugs with the handling
of OSCCAL value.

Regards,
Xiaofan