Re: using Byron Jeff's TLVProgrammer

Robert Pearce <[email protected]> Sat, 16 Dec 2006 23:19:13 +0000

Newsgroups	gmane.comp.hardware.microcontrollers.gnupic
Message-ID	<[email protected]>

On Sat, 16 Dec 2006, Byron A Jeff <[email protected]> wrote :
>>
>> >rw=25
>>
>> I assume this means there's a read/write selector on the Tait
>> programmer, on pin 25. Not all programmers have this signal.
>
>Pin 25 is a ground. So I'm real confused by this one.

D'oh! Sorry, I was mis-remembering. Since 25 is ground, I think this 
means the Tait programmer does NOT have a r/w control pin. The software 
could cope if it had one but in that case you'd not specify 25 here.

I think.

-- 
Rob Pearce                       http://www.bdt-home.demon.co.uk

The contents of this | Windows NT crashed.
message are purely   | I am the Blue Screen of Death.
my opinion. Don't    | No one hears your screams.
believe a word.      |