Re: [EE] USB Plastic Enclosure?

Looks like this is available from Polycase:
https://www.polycase.com/usb-31
Like you said, no opening for the wire exit,

If you want to pursue something more of a custom, I may be of help
there as well.
Your call sign web site would suggests you are in Tucson AZ. I'm also
in Tucson and I have
a half dozen 3D printers running. Easy enough to get something like
this in the mix.

-Denny

On Wed, Nov 13, 2024 at 10:16 PM Harold Hallikainen
<[email protected]> wrote:
>
> I'm working on a small circuit that has a four pin Molex on one end (
> https://www.digikey.com/en/products/detail/molex/0009484048/863365 ) and a
> two or three wire cable coming out the other end. I'm trying to come up
> with a simple inexpensive plastic enclosure. I THINK I can use a USB
> "dongle" type case. The PCB would probably extend out the rectangular hole
> where the USB A plug would go, then the Molex connector would be soldered
> to the extended PCB. At the other end, there should be a hole to run a two
> or three wire cable out. So far, all the USB enclosures I've found have
> the hole for the USB A plug, but not a hole at the other end for a cable.
> I could probably file out a hole in the plastic, but I wonder if something
> like that is available standard.
>
> Ideas?
>
> THANKS!
>
> Harold
> https://w6iwi.org
>
>
>
>
> --
> Not sent from an iPhone.
> --
> http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
> View/change your membership options at
> https://mailman.mit.edu/mailman/listinfo/piclist

-- 
http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
View/change your membership options at
https://mailman.mit.edu/mailman/listinfo/piclist