| Newsgroups |
gmane.comp.hardware.microcontrollers.pic |
| Message-ID |
<SPD9xRyeYvpJaq_NkQGhyQQNfrES2O7ef8vFeUJxOhjic3vgXkO4wXrP8mfLyeAW-hqZ9NjvQbMO8cTl1YZYrlN_xKPJ8ennGYOV6-s1m5M=@lees.monster> |
I would steer well clear of that job.
Cheers,
Martin.
On Saturday, 26 July 2025 at 15:52, Neil <[email protected]> wrote:
> Hi all,
>
> I'm in discussion with an entity who wants a couple products reverse
> engineered. It's actually their products (and have their brand), but
> they've parted ways with their CEM/design house who now doesn't want to
> hand over the design & assembly files. And they need to be the same as
> they are currently, else it may re-trigger a re-evaluation/approval by
> one of their major clients. What they need is gerbers, BOM, and assembly
> files so they can continue to make the product.
>
> For one product, I have a schematic, list of component part numbers (not
> calling it a BOM as there are no quantities), copper layout for all
> layers, and a sample assembled product.
> For the other product, all I have is the copper layout for all layers,
> and a sample assembled product.
>
> I'm trying to figure out what methods are available to reverse-engineer
> these products back to gerber and assembly files so they can continue to
> have it made by another CEM.
> For one product I can pretty much re-design the board from the
> schematic, but not sure how to figure out the component parameters (not
> just values like 0.1uf, but also tolerances, thermal characteristics,
> etc). One is a very tight board with lots of mosfets so thermal design
> will be important.
> For the other product, I can come up with a non-valued schematic (so I
> know where say capacitors and resistors would be), but won't easily know
> what the values are. Can all of these be measured?
>
> The products may be able to be re-engineered, but I expect re-interating
> prototypes to finalize the design would be somewhat different and would
> take longer.
>
> Any suggestions here? Are they any design houses that specialize in this?
>
> Cheers,
> -Neil.
>
> --
> http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
> View/change your membership options at
> https://mailman.mit.edu/mailman/listinfo/piclist