Re: [EE} Select on test resistors

On Mon, 18 Aug 2025 at 05:11, David C Brown <[email protected]> wrote:

> Rather pricey.  And long lead time
>

I'll assume "long lead" is not a pun :-).

You could form wire "cups" / half circlets / u-shape with pliers.
Wire comes out of pcb, turned down 180 degrees and then formed into a half
circle, concave side up.
Solder resistors into these.

For bonus points, make wire longer after exiting board.
Double over.
Wrap end around itself where it leaves the board.
Bend doubled portion into a U as above.

       Russell