Re: DCS80C400 won't boot - "ERROR Detecting RAM Size"
Bryan Armstrong <bryan.armstrong-6tN4nzCoH/[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
Daniel Mould wrote: > After retrying this process many times, I was actually able to get slush to > load once, and configure the network, etc. It all seemed to be working, but > then it died again the next day. Whenever I bring it up again now (or reset > and type "E") I get the same "ERROR Detecting RAM Size" messages as above. > I've tried reloading the firmware and slush, but this didn't help. Does > anyone know what's going on here? Check your power supply and reseat the module in the socket. The power supply must be a regulated 5V+-5%. -- -- Bryan Armstrong bryan.armstrong-6tN4nzCoH/[email protected] _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini