Re: Building Slush, Revisited

This message is from the old 390-only days, and it's warning you that what
you have built has some content that does not live in bank 7.  As long as
the size and the target address are OK, this message is nothing to worry
about.

Kris

----- Original Message -----
From: "Wes Stupar" <[email protected]>
To: "TINI" <TINI-6tN4nzCoH/[email protected]>
Sent: Tuesday, January 13, 2004 2:17 PM
Subject: [TINI]Building Slush, Revisited


> From the email archive of Apr 30, 2003 (see "DS80C400 TINI Memory
> Map..."), I get that there is a 0xF,EFF byte segment of flash on the
> TINIm400 for storage of the Slush code (i.e., 0x470,100 to 0x47F,FFF).
> This is 65,279 decimal.
>
> When I build Slush, builder prints "Warning, address exceeds normal TINI
> flash memory boundaries!", and it prints the size as 56,428. Why does it
> print this since the 56K is less than the 65K? The binary loads and
> runs, but there is some unreliability, and I don't know if it's because
> the binary is too big or if I have a problem with my board. My board is
> designed the same as the TINIm400 with regard to memory organization.
>
> Thanks, Wes
>
> _______________________________________________
> TINI mailing list
> TINI-6tN4nzCoH/[email protected]
> To UNSUBSCRIBE, edit your profile, or see list archives:
> http://lists.dalsemi.com/mailman/listinfo/tini
>


_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini