DHCP problem
Bogdan Dimitriu <[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
Hi !
We have a few TINI boards and we configured them to use DHCP. All of
them work fine with it except for one.
The way to configure them was:
ipconfig -r
ipconfig -d
The one that doesn't work with DHCP works fine if I assign it a static IP.
If I try to make it use DHCP, looking at my router's learned MAC
addresses I find that the server assigns it correctly an IP address. But
on the TINI board its IP/subnet mask are always 0.0.0.0/0.0.0.0,
although it announces leasing correctly from the DHCP server.
Here is the output of the "ipconfig" command on this board:
TINI /> ipconfig
Hostname : tini00d952.
Current IPv4 addr.: 0.0.0.0/0 (0.0.0.0) (active)
Current IPv6 addr.: fe80:0:0:0:260:35ff:fe00:d952/64 (active)
Default IPv4 GW :
Ethernet Address : 00:60:35:00:d9:52
Primary DNS :
Secondary DNS :
DNS Timeout : 0 (ms)
DHCP Server : 192.168.1.1
DHCP Enabled : true
DHCP Lease Ends : Thu Sep 12 08:43:36 GMT 2002
(23 hr, 59 min, 52 seconds left)
Mailhost :
Restore From Flash: Not Committed
My questions are: are there any known issues related to this problem ?
Is there any correction to this ? We have to use DHCP for our project
and we have a lot of TINI boards so we must be sure it is reliable.
Thank you in advance for any response.
Regards,
--
Bogdan Dimitriu | Software Architect
*ActiveMedia Technology*
1st. floor, Universal House, 88-94 Wentworth Street
London E1 7SA
Tel 44 207 247 5468
Fax 44 207 247 5477
Mobile 44 078 005 84425
[email protected] <mailto:[email protected]>
www.activemediatech.com <http://www.activemediatech.com>
_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini