Re: Immutable State Block
Bryan Armstrong <bryan.armstrong-6tN4nzCoH/[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
David Woodnutt wrote: > I have a 1MB TINI that appears to be unable to install an immutable state > block. There is nothing wrong with the library code that does the job; it is > running fine on another 1MB TINI (1.02e). The block is 4 bytes and is > installed in the library init. The first clue that something was wrong was > when native routines that accessed the block started failing intermittently. > Finally, the library init failed. Verify that the library is built against the 1.02e firmware. Verify that 1.02e final release firmware is on both boards. The errors you are seeing are very similar to a native library mismatch vs the firmware. -- -- Bryan Armstrong bryan.armstrong-6tN4nzCoH/[email protected] _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini