netcam loading
Eric <boyonweb-/[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
Hi, Based on netcam reference design, no TCP/IP stack required (ROM?). Correct me if I am wrong. When the board is turned on first time, the board will recognize RS232 interface automatically? Still use "java -classpath ... -flash -40" to get to netcam through com1 and load .tini file? Looks the ip address needs to be setup before the board can function. Secondly, can I use usb-to-parallel chip to interface with usb cam instead of parallel camera? Do I need to write usb device driver or connect parallel interface signals from microcontroller with assembly code for direct control? Thanks __________________________________ Do you Yahoo!? Yahoo! SiteBuilder - Free web site building tool. Try it! http://webhosting.yahoo.com/ps/sb/ _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini