Re: netcam loading

Eric wrote:

> Hi,
>
>   Based on netcam reference design, no TCP/IP stack
> required (ROM?). Correct me if I am wrong. When the
> board is turned on first time, the board will
> recognize RS232 interface automatically? Still use
> "java -classpath ... -flash -40" to get to netcam
> through com1 and load .tini file? Looks the ip address
> needs to be setup before the board can function.
>  
>
The netcam is using the TINI firmware, which has a TCP/IP stack built 
in. All configuration is done through a serial terminal program (CASH), 
based off SLUSH.

>   Secondly, can I use usb-to-parallel chip to
> interface with usb cam instead of parallel camera? Do
> I need to write usb device driver or connect parallel
> interface signals from microcontroller with assembly
> code for direct control?
>
>  
>
The camera driver was written specifically for the OmniVision camera, 
and if you want to use a different camera you will need to re-write the 
driver

Nick
_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini