Re: How to change the crystal multiplier?

Are you using the TINIm400 or a custom board?  If so, a crystal multipler of
4 is too fast for the flash, but a multiplier of 2 should be OK.

Kris

----- Original Message -----
From: "ÖìÏþ¸Õ" <[email protected]>
To: <bryan.armstrong-6tN4nzCoH/[email protected]>
Cc: <tini-6tN4nzCoH/[email protected]>
Sent: Thursday, January 29, 2004 7:47 PM
Subject: [TINI]How to change the crystal multiplier?


> I want to change the crystal multiplier in c,so I change the
file:startup400.a51,
> the value of XTALMULT may be 1, 2 or 4,the default value of it is 1,but
when I
> change XTALMULT into 2 or 4,the system halt,please tell me how to change
the
> crystal multiplier?thanks.
>
>
> _______________________________________________
> TINI mailing list
> TINI-6tN4nzCoH/[email protected]
> To UNSUBSCRIBE, edit your profile, or see list archives:
> http://lists.dalsemi.com/mailman/listinfo/tini
>


_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini