Help, Fried 1-wire output
Will Pickering <[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
Hi, In my haste to play with the 400 socket board I turned the power on with a bare temp-sensor laying under the socket board near the 5v power in. Sensor is verified ok via my USB 1-wire. Tini 400 boots and runs ok. ListOW.tini still reports the 1-wire MAC address button, but doesn't find my external temp sensor anymore. What is the best way to trace this back to see what I fried? Hopefully it is just U9 protection diode or U8 the 1-wire driver. Is there a schematic for teh 400 socket board? I see the one listed for the 390 on the ibutton page, but couldn't find one for the 400. Thanks in advance, Will _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini