Re: Problem with MDIO/MDC Interface
Bryan Armstrong <bryan.armstrong-6tN4nzCoH/[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
Sperlich, Klaus wrote: > Hi everyone! > I try to use the MDIO/MDC -interface to communicate > to a phy. > > But all i see is both on Pin 18 (MDC) periodic clocks signals and on > Pin 19 (MDIO) periodic data signals without using the readMII/ writeMII > classes. > Has anybody an idea? > Best regards! > Klaus Sperlich Try calling WriteMII twice in order to make your write take effect. This was discussed previously on the list. A fix for this will be out in firmware 1.13. -Bryan -- -- Bryan Armstrong bryan.armstrong-6tN4nzCoH/[email protected] _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini