Re: External Flash
Bryan Armstrong <bryan.armstrong-6tN4nzCoH/[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
Ferran Balaguer Del Pozo wrote: > After I do this test, I've mapped the memoy in CE0 and I can load in the > memory but a crc failure is produced. > > I supose that now I can load in the memory because I introduced the > commands to enable the memory write when it was mapped in CE3 > > I'm using the JavaKit options -allow and -ROMSize 1048576 I assume you are using a TINIm390. I also assume you are trying to program a flash that is not compatible with the AMD flash previously on the board. If this is what you are doing, the boot loader for 1.12 will not be able to program it. You will need to write a flash write routine and use it instead of the 1.12 loader. -- -- Bryan Armstrong bryan.armstrong-6tN4nzCoH/[email protected] _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini