Re: Mac OS X and TINI
Mike Reddy <[email protected]>
| Newsgroups | gmane.comp.hardware.microcontrollers.tini |
|---|---|
| Message-ID | <[email protected]> |
> 1) There's a jumper on the E20 to disable it, make sure it's enabled. I > don't know if there is one on the Vinculum board. It is enabled, and for the Vinculum board too. > 2) The DTR line is a separate wire in the serial cable connected to > pin 4. > Make sure that the cable you are using has this connected. sometimes > cables > built for specific uses don't use all the pins. Thought it might be the cable. Used three and none worked. Then used them on the PC and they worked for the reset. So it must be... > 3) Some really low cost USB-Serial dongles don't implement DTR. I think we have it. I am using a Belkin FCU109 with the beta OS X driver. Don't know if DTR is just not implemented or if the beta is not working. Have sent them an email. In the meantime, can readers send a list of working USB2serial converters for Macs that work under OS X. I will compile a summary and post it here. _______________________________________________ TINI mailing list TINI-6tN4nzCoH/[email protected] To UNSUBSCRIBE, edit your profile, or see list archives: http://lists.dalsemi.com/mailman/listinfo/tini