Re: EED0 signal state at power up

Bryan Armstrong <bryan.armstrong-6tN4nzCoH/[email protected]>
Newsgroups gmane.comp.hardware.microcontrollers.tini
Message-ID <[email protected]> 
Massimo Piovera wrote:
> Is it possible to change the state of this signal at power up ?

I believe EED0 defaults to 0 on SMC Ethernet chip power up.  As soon as 
your program gains control of the system, you can then change the state 
to the desired level.

-- 
--
Bryan Armstrong
bryan.armstrong-6tN4nzCoH/[email protected]


_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.