Re: Loading MAC address (without using NetBoot)

Bryan Armstrong <bryan.armstrong-6tN4nzCoH/[email protected]>
Newsgroups gmane.comp.hardware.microcontrollers.tini
Message-ID <[email protected]> 
Bernard wrote:
> I am designing very simple DS80C400 Microcontroller system with using socket
> ROM-functions but without using NetBoot!
> May I load the MAC address with "ETH_LoadEthernetAddress" procedure from
> "Application Note 712: DS80C400 Ethernet Drivers" instead of using DS2502
> IC?

Robert might correct me, but using the above function should work as 
advertised and set the MAC address.  This will allow you to pull your 
MAC address from any source.

-- 
--
Bryan Armstrong
bryan.armstrong-6tN4nzCoH/[email protected]


_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.