Re: TCP/IP Stack in DS80C400

Robert Muchsel <robert.muchsel-6tN4nzCoH/[email protected]>
Newsgroups gmane.comp.hardware.microcontrollers.tini
Message-ID <[email protected]> 
> Any one can guide me on how to make the BSD calls route the tcp/ip raw
> packets on serial port ? Does the BSD functions, send data to ethernet
> controller directly when called ? For example, when connect(..) function is
> called,  low level DS80C400 prepares the tcp/ip raw packet  in a buffer and
> want us to sends it on serial port. Is that possible ????

This would require installable network interfaces which are
unfortunately not supported at this time (excepting the PPP module for
the TINI runtime).

-- 
  Robert Muchsel - Dallas Semiconductor - http://www.maxim-ic.com/TINI/

_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.