Re: why does slush not work in my system(baud-rate is 115200)?

What address are you building your application for?  I think you'll need to
build your application for address 200000h, but you'll need to load it in
JavaKit at address 400000h.  You could do this by altering the extended
address record in the hex file before you load it.

Kris

----- Original Message -----
From: "ÖìС¸Õ" <[email protected]>
To: <bryan.armstrong-6tN4nzCoH/[email protected]>
Cc: <tini-6tN4nzCoH/[email protected]>
Sent: Tuesday, March 02, 2004 9:29 PM
Subject: {Spam?} Re: [TINI]why does slush not work in my system(baud-rate is
115200)?


>
> I want to  change CE sizes in the startup code. So I changed the file
>
change_ce.tx(ftp://ftp.dalsemi.com/pub/tini/ds80c400/c_libraries/thirdparty/
change
> _ce.txt)according to my own system and add it into the startup code.when I
> download the code to the RAM,the result of running seems ok,bucause I can
see the
> result of print from Javakit,but when I download the code to the flash
ROM, I can
> not see anything from JavaKit.I know that after a rom_init the
configuration is
> 2Mb per CE and 24 bits contiguous addressing mode.I want to configure CE
is 1Mb
> per CE.Can someone help me?
> The memory configuration of my system is:
>
>   two 512Kb of RAMs on CE0 (according to decoding using FPGA)
>   1Mb of flash on CE2
>
>
> Thanks!
>
>
>
> _______________________________________________
> TINI mailing list
> TINI-6tN4nzCoH/[email protected]
> To UNSUBSCRIBE, edit your profile, or see list archives:
> http://lists.dalsemi.com/mailman/listinfo/tini
>


_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini