Re: RE: problems starting JavaKit

Bryan Armstrong <bryan.armstrong-6tN4nzCoH/[email protected]>
Newsgroups gmane.comp.hardware.microcontrollers.tini
Message-ID <[email protected]> 
Saurabh Mukadam wrote:
> Board is interface with PC through serial port using only Tx, Rx and Gnd
> line. There is no DTR line used to reset the board. DS80C400 is
> resetted manually when required.

Saurabh,

DTR is required to notify the loader that a binary segment load is complete.

-- 
--
Bryan Armstrong
bryan.armstrong-6tN4nzCoH/[email protected]


_______________________________________________
TINI mailing list
TINI-6tN4nzCoH/[email protected]
To UNSUBSCRIBE, edit your profile, or see list archives:
http://lists.dalsemi.com/mailman/listinfo/tini
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.